Auto Present Door Handles

Packing List

  1. Door Handle * 4

  2. Latch Motor * 4

  3. Signal Wire * 4

  4. Power and CAN Wire * 1

  5. Control Unit * 1

  6. Zip Tie

  7. Washer * 4

  8. Spacer * 4 (For 2021+ Made in USA Model 3 only)

Recommended Tools

  1. 8mm Hex Socket

  2. 10mm Hex Socket

  3. 13mm Hex Socket

  4. T-20 Screwdriver

  5. T-30 Screwdriver

  6. Wrench

  7. Small Flat Head Screwdriver

  8. Pry Tool

  9. Electrical Tape

  10. Diagonal Cutting Pliers

  11. Wire Fishing Tool

Installation

Step 1 - Follow the Soft Closing Doors instructions to run the wires

Run signal wires to each of the doors

Step 2 - Follow the Soft Closing Doors instructions to get access to the door handle

Remove the door panel and window glass on each door you are going to install

Step 3 - Remove the OEM Door Handle

Remove the covers from the door panel

Remove the 3 screws of the door handle

Now you can remove the door handle assembly

Step 4 - Install the Latch Motor

Push the clips and remove the plastic piece as shown below

Remove the hinge (it can be metal / plastic depending on car year)

Now you can remove the door handle

Remove the 2 screws holding the sensor

Drill 2 holes to fit the metal plate.

(WIP)

Assemble the auto present unit with the door handle

Step 5 - Assemble the Door

Plug the OEM door handle wire to the connector in our kit, then the other end or connector to the original connector.

Install the handle assembly to the door panel

Caution: While installing the window glass, use the bolts with 2 washers we provided instead