Speaker Activation Wire (Variant C)
This is the installation guide for Tesla Model 3 Speaker Activation Wire (Variant C) from EVOffer.
Last updated
This is the installation guide for Tesla Model 3 Speaker Activation Wire (Variant C) from EVOffer.
Last updated
Activation up to 6 speakers on Model 3 Standard Range Plus (2022+).
Speaker Activation Wire * 1
Positap * 2
Subwoofer Output Wire * 1 (Optional - for Subwoofer Output)
Rear-shelf Speaker * 2 (Optional - for Rear-shelf Speaker)
Rear-shelf Speaker Wire * 1 (Optional - for Rear-shelf Speaker)
Screws * 6 (Optional - for Rear-shelf Speaker)
MCU Connection
Right Tweeter Connection
A-pillar Speakers & Left Tweeter Connection
Rear-shelf Speakers Connection
Release the 3 push clips that attach the passenger footwell cover. This should be on the right side of a LHD car and left side of a RHD car.
Disconnect the electrical harness from the puddle light connector and emergency speaker connector. You may also find a OBD connector on newer models.
Disconnect the two connectors located at the bottom right and connect our Y connecting pairs to the original wires and sockets.
For RHD cars, you need to run the remaining wires to the right side of the car under the carpet.
Remove the middle A-pillar trim piece on the right side of your car.
Remove the push clip holding the lower A-pillar trim piece.
Now you can remove the whole lower A-pillar trim piece.
For Variant A cars, you can simply connect the 2-pin wire to the idle socket.
For Variant B cars, you need to cut the connector and connect with the 2 positap provided.
Spot the out-most connector below the C-pillar.
Find the red and white wires. They are corresponding to yellow with black and yellow wires on our speaker activation wire.
Remove the push clip holding the B-pillar on the right side of your car.
Locate the blue connector below the white connector shown in the picture. Disconnect it and connect our Y connecting pair to the original wire and socket.
Pull up the bottom C-pillar trim piece to run the wire to C-pillar.
Fold down the 2nd row seat. Pull the bolster gently from the bottom until it is loosen.
Now you can pull out the whole bolster out from the top.
If you don't plan to install the rear-shelf speakers, you can hide the remaining wires in the C-pillar and complete the installation.
Now the system is ready to be tested. Try to adjust the balance of the speakers and see if all the speakers are working now.
Tidy up the wires and install all the trim pieces in reverse steps and the installation is completed.
Model Year | Build | Tweeters | A-pillar Speakers | Rear-shelf Speakers | Remarks |
---|---|---|---|---|---|
2022/01 +
Fremont
User need to install the rear-shelf speakers;
Tap wires below A-pillar
2021/11 - 2022/05
Shanghai
User need to install the rear-shelf speakers;
Tap wires below A-pillar
2022/06 +
Fremont
Placeholder for rear-shelf speakers is cancelled;
Tap wires below A-pillar