Gear and Turn Signal Stalk
This is the installation guide for Tesla Model 3 (2024+) Gear and Turn Signal Stalk from EVOffer.
Packing List
Recommended Tools
Small Flathead Screwdriver
Phillips Screwdriver
T-20 Screwdriver
T-45 Screwdriver (with long wrench)
Installation
Step 1 - Remove the Steering Wheel
Insert a small flathead screwdriver into the 2 holes behind the steering wheel to pop out the airbag.
Disconnect the yellow and red connectors.
Remove the center screw with a T-45 screw driver with long wrench.
Take a picture of the center screw position. You can refer to this picture when you put the steering wheel back later. Remove the steering wheel afterwards.
Step 2 - Remove the Steering Column Covers
Pull the top cover outward to release the cover.
Remove the 2 T-20 screws and take out the bottom cover.
Step 3 - Install the Gear and Turn Signal Stalk
Slide the gear stalk / turn signal stalk into the bracket. Tighten the screw on the right bracket to secure the stalk.
Step 4 - Install the Gear Stalk Bracket
Install the 2 brackets with stalks on the steering column. Use the 2 retainers to connect both brackets at the top and bottom.
Step 5 - Wire Connection
Remove the A pillar kick panel on the right side (no matter you have a LHD or RHD car).
Connect the CAN connector and power connector respectively.
Run the wire up to the steering wheel column and connect to the stalks.
Step 6 - Install the Covers
Slide in the bottom cover.
Align the lower holes and secure the cover by Phillips screws.
Install the top cover.
Install the side covers below the gear stalk.
Step 7 - Finishing Up
Test the functionality of the gear and turn signal stalk. If everythings work properly, put the steering wheel and the airbag back to their original position.
Last updated