Electric Tailgate
This is the installation guide for MG4 Electric Tailgate from EVOffer.
Last updated
This is the installation guide for MG4 Electric Tailgate from EVOffer.
Last updated
After installation, the decoder must be matched by adjusting the tailgate to the highest point, pressing the tail button for 5 seconds, and releasing after a long sound. This completes the matching operation (power replacement operation).
The manual does not specify wiring, as installation does not require it.
External Release
Add-on Trunk Button
Add-on Driver Button *
Key Fob **
* Long Press the button to open
** Long Press the button to open and close
The tailgate switch speed can be adjusted across five settings, with the default set to gear 4, the lowest at gear 2, and the highest at gear 6. To adjust:
Press and hold the add-on trunk button.
Listen for the buzzer. Two consecutive sounds indicate gear 2 is set, three sounds for gear 3, and so on.
To adjust the tailgate to the desired height:
Bring the tailgate to the appropriate height.
Press and hold the add-on trunk button for 5 seconds until you hear a beep, indicating successful height setting.
The tailgate will open to this preset height on subsequent uses.
Remove the original trim panel as indicated by arrows in the figure.
Use a flat screwdriver to tilt up the ball head steel sheet and remove the left and right struts of the original car.
Remove the original car body bracket and install our distribution bracket (identical for left and right).
Electric Strut Installation
Refer to the schematic diagram for installation. Ensure the pole ball head card is properly placed and the strut line faces the body.
Pass the stay line (left and right) through the reserved hole of the original vehicle.
Remove the original lock block and install the lower suction lock.
Install on the left side of the trunk.
Unplug the original car lock block plug and connect with the distribution plug.
Locate under the right rear door foot pedal.
Take the electrical position in the center console under the main driver to find the safety box. Connect to 12V normal power with insurance over 20A.
Secure the controller to the left of the tailgate.
Install the front button in the opening of the main driver's center console as shown.
After making a hole in the tailgate trim panel below, install the rear button.
Ensure all lines are correctly positioned and secured.
After installation, test all functions to ensure proper operation.
