Plaid Style Performance Sport Seat (Premium Version)
We are offering pre-assembled seats for Model S/X 2020. However, the seat is partially pre-assembled on Model S/X 2021+.
Driver-side Backrest
Driver-side Seat Base
Passenger-side Backrest
Passenger-side Seat Base
Step 1: Remove the Original Seat
Before beginning, ensure the vehicle is powered off.
For Model S/X (Pre-Refresh / 2020): Please refer to the guide below for seat removal instructions.
For Model S/X (Refresh / 2021+): Please refer to the guide below for seat removal instructions.
Coming Soon
Step 2: Foam & Leather Replacement
Special Instructions for Model S/X (2021+)
Important Note for Passenger Side Installation
Unlike the driver's side, the Passenger Side Seat Base for 2021+ models is not pre-assembled. This is intentional to allow for the transfer of factory sensors.
1. Weight Sensor (Occupant Classification System)
The weight sensor is located between the foam and the leather of the original seat. Because this sensor is calibrated to the vehicle, it must be transferred to the new seat base.
Separate the original leather from the foam to access the sensor.
Transfer the sensor sheet to the new foam.
2. Active Noise Cancellation (ANC) Module
The Refresh seats contain an ANC module embedded inside the foam of the backrest.
Extract the ANC module from the original foam.
Relocate and secure the module directly onto the metal seat frame using double-sided tape or adhesive.
Watch the detailed walkthrough for these specific steps:
Step 3: Active Side Bolster Install
You can also find the user manual here:
Last updated